Queensgate Appliance Repair
Cincinnati, OH
Eight appliances, one call
If it keeps food cold, washes, dries, or cooks, there is a good chance we work on it. Every repair below is done at your home, by a technician who brings the tools and the common parts for that kind of machine. When something has to be ordered, we tell you what it is, why it failed, and when we will be back to install it.
A fridge that won't hold temperature can cost you a week of groceries, so we treat it as a priority call. We test the compressor, start relay, condenser and evaporator fans, defrost heater and timer, thermostat and door gaskets. Side-by-side, French door, top and bottom freezer models are all covered.
Water that won't drain, a drum that won't spin, a door that stays locked, or a machine that shakes the whole room. We replace drain pumps, door locks, lid switches, shock absorbers, drive belts, bearings and water inlet valves on top-load and front-load washers.
Most dryer calls come down to no heat, long drying times, or a loud thumping or squealing drum. We work on gas and electric dryers: heating elements, igniters, gas valve coils, thermal fuses, thermostats, idler pulleys, rollers and belts. We also check the venting, because a clogged vent shortens the life of the dryer.
Cloudy or gritty dishes, standing water, leaks onto the floor, or a control panel that won't respond. We clean or replace wash and drain pumps, check spray arms and filters, test the inlet valve and float switch, and fix door latches and seals so the cycle runs start to finish.
An oven that won't heat, heats unevenly, or runs far hotter than the dial says. We test and replace bake and broil elements, igniters, temperature sensors, thermostats and control boards on wall ovens and range ovens, gas and electric. We calibrate the temperature before we finish.
Burners that won't light, click without stopping, or only work on high. On gas cooktops we deal with igniters, spark modules and burner valves. On electric and glass-top stoves we replace surface elements, infinite switches and the wiring behind them.
No ice, small or hollow cubes, ice that tastes off, or a dispenser that jams. We check the water inlet valve, water line, fill tube, ice maker module and dispenser motor, and look for a frozen line, which is one of the most common causes.
Built-in freezer compartments and standalone upright or chest freezers. If it is frosting over, running all the time, or letting food soften, we test the sealed system, defrost components, fans and door seals and get it holding zero again.
Our process
Whether it is a dryer that won't heat or a fridge that won't cool, the job goes the same way. Four plain steps, in this order, every time.
We listen to what you have noticed, then test the appliance ourselves. A symptom can have three or four possible causes, and we narrow it down before we touch a part.
We tell you which part failed and what it takes to replace it. We use parts made to fit your model, because a poor-fitting part tends to fail again.
We protect the floor, keep the work area tidy and explain what we are doing as we go. No surprises, and no mess left behind.
We run a full cycle, check temperatures or water flow, and make sure the original problem is gone before we pack up.
Calling is the fastest way to get on the schedule. Have the appliance type and brand handy, and tell us what it is doing. We take calls Monday through Friday from 7:30 am to 10:00 pm, and on weekends from 8:30 am to 8:30 pm.
If you can't call right now, you can also send a short request from our Contact page and we will call you back.